SZDOIT 2-way L298N Motor Drive Board Module DC Stepper Motor RC Robot Car Chassis Part For Arduino High Power

0 stars, based on 0reviews
$4.20 / piece
  • Red
Quantity: - + 90items available
Inquiry Now

Item specifics

Brand Name:
Composite Material
Technical parameters:
Value 4
Bottom Plate
Model Number:
For Vehicle Type:
Tool Supplies:
Remote Control Peripherals/Devices:
Remote Controller
Vehicles & Remote Control Toys
Upgrade Parts/Accessories:
Four-wheel Drive Attributes:
RC Parts & Accs:


  • Module name: double H bridge motor drive module
  • Main control chip: L298N
  • Working mode: H-bridge drive (two-way)
  • Logic voltage: 5V
  • Driving voltage: 5-35V
  • Logic current: 0-36mA
  • Drive current: 2A (MAX single bridge)
  • Storage temperature: -20 ° C ~ +135 ° C
  • Maximum power: 25W
  • Peripheral size: 43*43*27mm
  • Weight: 30g


  • This module uses ST company's L298N as the main driver chip, featuring strong driving capability, low heat generation and strong anti-interference ability.
  • This module can use the built-in 78M05 to take power through the drive power supply part, but in order to avoid damage to the voltage regulator chip, when using a drive voltage greater than 12V, please use an external 5V logic power supply.
  • This module uses a large-capacity filter capacitor and a freewheeling protection diode to improve reliability.



  • When your drive voltage (the above figure is 12V input, the actual acceptable input range is 7-12V) is 7V-12V, you can enable the onboard 5V logic supply, when using the onboard 5V power supply, the interface Do not input voltage to the +5V supply, but can draw 5V for external use. (This is a regular application!)
  • When the driving voltage is higher than 12V, less than or equal to 24V (the chip manual can support up to 35V, but according to experience, 298 conservative application of maximum voltage support to 24V is very great!), for example, to drive a motor with a rated voltage of 18V. First, the jumper cap with the onboard 5V output enable must be removed. Then access 5V outside the 5V output port
  • 5V enable is a 5V control signal. When this signal input is valid and the power supply in the motor drive module is normal, the motor drive module outputs current. Otherwise, there is no current on the motor even if the power supply is normal.
  • The voltage supplies power to the L298N internal logic circuit. (This is a non-conventional application of high voltage drive!)

Shipping list:

  • 1pcs motor drive module




Hot Sales

    Recent Reviews