SZDOIT 2-Way/4-Way Motor Servo Drive Board High Current L298P Chip RC Robot Car Chassis Part For Arduino UNO R3 Motor Shield

Product introduction:

• The UNO-Compatible Motor Shield is a high current motor drive module that is fully compatible with the Arduino. The circuit module has a stacking design and can be directly connected to the Arduino. Its control port is six, including the speed, direction and brake control of the two motors.
• The module adopts the excellent high-power motor dedicated full-bridge chip L298P produced by STMicroelectronics. It can directly drive 2 DC motors or 1 stepping motor, and the drive current can reach 2A. The layout of the circuit diagram is reasonable, the chip package is very convenient to install, and the output end is protected by a high-speed Schottky diode.
• The module has added an infrared sensor HX1838 that accepts control signals from a remote infrared remote control, making it easier to remotely control motor motion.
• The module also brings out multiple pins such as Power, IIC, UART, AIO, DIO, and WiFi interface, which can easily allow users to access peripheral devices such as communication modules and sensors. Therefore, the module has multiple functions such as an expansion board and a motor drive board.
• The module adopts the humanized design scheme and uses the power button switch to facilitate the user to perform plug-free debugging.
• Modules Each motor drive interface provides two connectors that can drive 2-way or 4-way car/tank chassis.

Features:

• Power input voltage: 7V ~ 12V
• Logic working current Iss: ≤36mA (Vi=L), ≤12mA (Vi=H)
• Drive part operating current Io: ≤ 2A
• Maximum power dissipation: 25W (T=75°C)
• PWM, PLL two drive modes
• Control signal input level: high level: 2.3V ≤ Vin ≤ 5V; low level: -0.3V ≤ Vin ≤ 1.5V
• Working temperature: -25 ° C ~ +85 ° C
• Drive form: dual high power H-bridge drive
• Arduino control port: 3,9,12 (A motor); 8,11,13 (B motor)
• Module weight: about 26g

Shipping list:

• 1pcs drive board